![]() ![]() Note: Make sure the water level in the water reservoir is not over the ice collecting tray. Open the lid and fill the water reservoir with water. Press ‘STOP’ button then press ‘START’ button to restart the Ice Maker after some of the ice is scooped out. ICEFULL: This light will come on with a beep when the ice has reached the maximum capacity of the storage cabinet.You will need to add water and press the ‘STOP’ then the ‘START’ button to restart the Ice Maker. DEFICIENT: This light will come on with a long beep.(Note: The selected mode will stay as selected unless changed or a power failure occurs. SELECT: Ice size selection (S) small, (M) medium or (L) large.This button is also used to start the ice making cycle. If no water is pumped out to the water tray over two cycles, open the drain cap and let several drops of water drain out.For the first three cycles, the ice may be small and irregular in size.Ensure that the voltage indicated on the Ice Maker corresponds with the voltage in your house.Before using the Ice Maker for the first time: Wait 2 hours after you have positioned it.Do not install the Ice Maker near an oven, radiator, or any other heat source. To ensure proper ventilation for your Ice Maker, allow 150mm of space at the top, the back and on each side. The Ice Maker should be placed horizontally on a level surface.Remove all packing material and carefully check your Ice Maker to ensure it’s in good condition and that there is no damage to it or the power cord and plug.When transporting, do not incline on over 45° angle. Do not turn the Ice Maker upside down as this may damage the compressor and sealed system. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |